Skip to main content

Benbrack

South Scotland · Wind · Status unverified

Lifecycle
Status unverified
Declared output
—
Sourced installed capacity
67 MW
Declared utilisation
—

Output history

Unavailable because this deployment has no stored history for that range.

Reported availability

REMIT unavailability affecting this station over the last 12 months.

Unit lifecycle and sources

Effective-dated status is applied before station capacity and technology are calculated.
BM unitTechnologyRegistered capacityCurrent lifecycle
BENBW-1Wind67 MWUnverified

No sourced lifecycle event applies to these units. Registry membership does not establish operating status; zero declarations do not establish retirement.

Physical capacity evidence

BENBW-1 · 67.1 MW · evidenced from 2026-03-10

The owner reports 15 installed Vestas turbines and 67.1 MW total generation capacity, with the turbines operational while the project takes its final steps toward commercial operations. BENBW-1 is the sole mapped generation BMU. This establishes the physical rating after the dated release, but does not mark the unit lifecycle operating; the 67 MW registry reference remains separate.

Source 2026-03-09 · reviewed 2026-09-19

Operator capacity source

Whole-site registered total: 67 MW, including retired units.

Registered capacity is the value retained in the committed BM-unit source snapshot. “Not retained” means the registry no longer supplied a positive figure; it does not mean the unit historically had no capacity. If a unit with a retirement event publishes a non-zero live declaration, the live declaration keeps it in the operating fleet pending review.

About this asset

Benbrack is a unverified wind site in South Scotland. It has 1 non-retired (1 unverified) and 0 retired mapped Balancing Mechanism unit, with 67 MW on the displayed capacity basis.

The source catalogue has no site coordinate, so the explorer shows a regional position rather than an exact location.

Current output is the operator’s declared Physical Notification. Metered output is published later and is shown as the solid portion of the history chart; outage shading comes from REMIT notices.